Specializing in laser, CNC equipment solutions
Corporate News
Your current location:主页 > en > News Center > Corporate News >

Laser marking machine operating security matters

Article Source:http://www.shcmlaser.com Release Time:2015-12-23 09:52 Views:
10.64um laser wavelength laser marking machine is at work when there is damage to human skin, so an operator in the course of one thing to pay attention to safety. Laser marking machine at work, it is very dangerous if a failure occurs, the novice must be trained professionals to operate independently, based on the experience we summarize the 13 security detail laser cutting machine work, hoping to use laser equipment is being help friends, operational details are as follows:
1. Observe the general laser equipment safety procedures. Start the program starts in strict accordance with laser laser.
2. The operator must be trained and familiar with the device structure, performance, control operating system knowledge.
3. According to the provisions of labor Wear protective equipment, in the vicinity of the laser beam must comply wear protective glasses.
4. We did not understand the potential danger before certain whether the material can be laser irradiation or heat, not its processing, in order to avoid smoke and vapors
5. When the device start operating personnel are not allowed to leave their posts or Trustee to be managed, as indeed need to leave should stop or cut off the power switch.
6. To fire extinguisher readily available and in place; to turn off the laser or the shutter is not working; do not put paper, cloth, or other combustible materials in the vicinity of the laser beam is unprotected.
7. When abnormality in the process, should be immediately shut down, timely troubleshooting, or reporting officer.
8. Keeping the laser, the bed and around the site clean and orderly, no oil, parts, lumber, scrap pile according to regulations.
9. When using gas cylinders, should avoid crushing welding wires, to avoid leakage accidents. The use of gas cylinders, gas cylinders shall be subject to surveillance transport regulations. Prohibit cylinders prolonged sun exposure in the sun or near a heat source. When the cylinder valve open, the operator must stand on the side of the lip.
10. To comply with safety regulations when servicing high pressure. Every 40 hours or weekly maintenance work every 1000 hours of operation or maintenance every six months, to be conducted in accordance with rules and procedures.
11. After low speed should be manually turned on X, Y directions starting machine, check to make sure whether the abnormal situation.
12. After a new workpiece program input, you should first test run and see what happens.
13. When working, observe the operation of the machine, in order to avoid cutting out the effective stroke range or two collision accident.

Recommended Products
switchboard:021-61558010 fax:021-59556319 QQ:1158518808 Sales calls:021-61558300
Micro-channel public number:shcmlaser-cnc fax:021-59556319 Company email:sales@shcmlaser.com
All rights reserved:Shang Hai Chuang Ming Laser equipment plant Technical Support:Yong Yan Technology